User Manual

6-6
5038AD-I User's Manual
3. Push the drive tray toward the front of the chassis and out.
4. Secure the storage drive to the drive tray with screws through the bottom of
the tray. To install two 2.5" drives, use the optional bracket (P/N MCP-220-
00044-0N) as shown.
5. Slide the drive tray into the chassis until it clicks into place.
Installing Disk Drives into the Cage
You can install up to four 2.5" drives into the dedicated center cage. You can also
install three drives into each of the upper and lower combination cages.
1. Open the chassis left side cover.
2. Remove the drive mounting bracket from the cage. Pinch the tabs and pull
out.
3. Secure the drive into the mounting bracket.
• For 2.5" drives in the dedicated bays (center cage), fl ex the drive bracket
and drop the drive in with the connector side facing into the chassis.
• For 3.5" drives in the combo bays (top or bottom cages), fl ex the drive
bracket and drop the drive in with the connector side facing into the chassis.
• For 2.5" drives in the combo bays, use screws through the bottom of the
bracket to secure the drive with the connector side facing into the chassis.
4. Slide the assembly into the cage.
5. Connect the storage device cables from the motherboard.
Figure 6-7. Installing Drives and Mounting Brackets in to the Cage