Datasheet

Chapter 5: Advanced Serverboard Setup
5-3
Figure 5-1. 604-pin PGA Socket: Empty and with Processor Installed
Warning! Make sure you lift the lever completely when installing
the CPU. If the lever is only partly raised, damage to the socket or
CPU may result.
!
5. Screw in two diagonal screws until just snug (eg. screws #1 and #2 in Figure 5-2
- do not fully tighten), then do the same with the remaining two diagonal screws.
Finish by fully tightening all four screws (see Figure 5-2).
6. If installing two processors, repeat these steps to install the second processor
in the CPU #2 slot.
Figure 5-2. Heatsink Installation (heatsinks are optional)