User`s manual

5-4
S
UPERSERVER 6014P-32/6014P-32R User’s Manual
5-3 Connecting Cables
Now that the processors are installed, the next step is to connect the cables to
the serverboard. These include the data (ribbon) cables for the peripherals and
control panel and the power cables.
Connecting Data Cables
The ribbon cables used to transfer data from the peripheral devices have been
carefully routed in preconfi gured systems to prevent them from blocking the fl ow
of cooling air that moves through the system from front to back. If you need to
disconnect any of these cables, you should take care to reroute them as they were
originally after reconnecting them (make sure the red wires connect to the pin 1
locations). If you are confi guring the system, keep the airfl ow in mind when routing
the cables. The following peripheral data cables (with their connector locations
noted) should be connected. See the serverboard layout diagram in this chapter
for connector locations.
 Floppy Drive cable (JFDD1)
 DVD-ROM Drive cable (IDE1)
 SAS cables (JSM2)
 Control Panel cable (JF1, see next page)
Connecting Power Cables
The X6DHP-3G2 has a 20-pin primary power supply connector designated "JWR1"
for connection to the ATX power supply. Connect the appropriate connector from
the power supply to JWR1 to supply power to the serverboard. See the Connector
Defi nitions section in this chapter for power connector pin defi nitions.
In addition, your power supply must be connected to the 9-pin Secondary ATX
Power connection at JPWR1.