User`s manual

5-18
S
UPERSERVER 6014P-32/6014P-32R User’s Manual
JLAN Enable/Disable
Change the setting of jumper JPL1
to enable or disable the JLAN1 and
JLAN2 Ethernet ports. See the table
on the right for jumper settings. The
default setting is enabled
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application hangs. Pins 1-2 will cause
WD to reset the system if an applica-
tion hangs. Pins 2-3 will generate a
non-maskable interrupt signal for the
application that is hung up. See the
table on the right for jumper settings.
Watch Dog must also be enabled in
BIOS. Note: When enabled, the user
needs to write their own application
software in order to disable the Watch
Dog Timer.
JLAN Enable/Disable
Jumper Settings (JPL1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
SAS Controller Enable
JPS1 enables or disables the Adapt-
ec 9140W SAS controller on the
serverboard. See the table on the
right for jumper settings. The default
setting is enabled.
SAS Controller Enable
Jumper Settings (JPS1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled