Datasheet

2-10
SUPERSERVER 6015C-M3/6015C-MT User's Manual
2-6 Checking the Chassis Setup
Next, you should check to make sure the peripheral drives and the SAS/SATA
drives and SAS/SATA backplane have been properly installed and all essential
connections have been made.
Checking the Drives
All drives can be accessed from the front of the server. For servicing the 1.
DVD-ROM drive, you will need to remove the top chassis cover. The SAS/
SATA disk drives can be installed and removed from the front of the chassis
without removing the top chassis cover.
Refer to Chapter 6 if you need to reinstall a DVD-ROM drive to the system.2.
Depending upon your system's confi guration, your system may have one 3.
or more SAS/SATA drives already installed. If you need to install SAS/SATA
drives, please refer to the appropriate section in Chapter 6.
Checking the Airfl ow
Airfl ow is provided by four high-performance 4-cm input fans. The system 1.
component layout was carefully designed to promote suffi cient airfl ow through
the small 1U rackmount space.
Also note that all power and data cables have been routed in such a way that 2.
they do not block the airfl ow generated by the fans.
Providing Power
Plug the power cord from the power supply unit into a high-quality power strip 1.
that offers protection from electrical noise and power surges.
It is recommended that you use an uninterruptible power supply (UPS).2.
Press the power button on the front of the chassis. 3.