Datasheet

Chapter 5: Advanced Serverboard Setup
5-9
5-7 Adding PCI Cards
The 6015C-M3/6015C-MT includes a preinstalled riser card (p/n CSE-RR1U-E8)
designed specifi cally for use in the SC813MTQ-520C 1U rackmount chassis. This
riser card allows a standard size PCI-E x8 card to sit at a 90 degree angle so it
can fi t inside the chassis.
PCI Card Installation
The CSE-RR1U-E8 riser card has already been preinstalled into the serverboard.
Perform the following steps to add an add-on card:
Remove the PCI slot shield on the chassis by releasing the locking tab.1.
Insert the add-on card into the riser card.2.
Secure the add-on card with the locking tab.3.
Possible System Memory Allocation & Availability
System Device Size
Physical Memory
Remaining (Available)
(4 GB Total System
Memory)
Firmware Hub fl ash memory (System BIOS) 1 MB 3.99
Local APIC 4 KB 3.99
Area Reserved for the chipset 2 MB 3.99
I/O APIC (4 Kbytes) 4 KB 3.99
PCI Enumeration Area 1 256 MB 3.76
PCI Express (256 MB) 256 MB 3.51
PCI Enumeration Area 2 (if needed) -Aligned on 256-
MB boundary-
512 MB 3.01
VGA Memory 16 MB 2.85
TSEG 1 MB 2.84
Memory available to OS and other applications 2.84
Note: Due to memory allocation to system devices, memory remaining available
for operational use will be reduced when 4 GB of RAM is used. The reduction in
memory availability is disproportional. Refer to the table below for details.