Datasheet

5-12
SUPERSERVER 6015C-M3/6015C-MT User's Manual
Reset Connector
The reset connector is located on pins
3 and 4 of JF1 and attaches to the
reset switch on the computer chas-
sis. See the table on the right for pin
defi nitions.
PW_ON Connector
The PW_ON connector is on pins 1
and 2 of JF1. This header should be
connected to the chassis power but-
ton. See the table on the right for pin
defi nitions.
5-9 Connector Defi nitions
ATX Power Connector
The primary power supply connector
(JPW2) on the X7DCL-3/X7DCL-i
meets the SSI (Superset ATX) 24-pin
specifi cation. Refer to the table on the
right for the pin defi nitions of the ATX
24-pin power connector. You must
also connect the 8-pin (JPW1) proces-
sor power connector to your power
supply. Refer to the table below right
for the PW2 (12V) connector.
Required Connection
ATX Power 24-pin Connector
Pin Defi nitions (JPW2)
Pin# Defi nition Pin # Defi nition
13 +3.3V 1 +3.3V
14 -12V 2 +3.3V
15 COM 3 COM
16 PS_ON 4 +5V
17 COM 5 COM
18 COM 6 +5V
19 COM 7 COM
20 Res (NC) 8 PWR_OK
21 +5V 9 5VSB
22 +5V 10 +12V
23 +5V 11 +12V
24 COM 12 +3.3V
Reset Button
Pin Defi nitions (JF1)
Pin# Defi nition
3 Reset
4 Ground
Power Button
Pin Defi nitions (JF1)
Pin# Defi nition
1 PW_ON
2 Ground
Processor Power Connector
In addition to JPW2, the 12V 8-
pin processor power connector at
JPW3 must be connected to your
serverboard. See the table on the right
for pin defi nitions.
Processor Power
Connector
Pin Defi nitions
Pins Defi nition
1 through 4 Ground
5 through 8 +12V