Datasheet

Chapter 6: Advanced Chassis Setup

6-3

6-3 System Fans

Four 4-cm high-performance 12500 rpm fans provide the cooling for the SuperServer

6015C-M3/6015C-MT. The chassis includes air seals under the fans and at the

chassis cross section, which separates the drive bay area from the serverboard

area of the chassis to promote better airﬂ ow. It is highly important that the air seal

is properly installed and making a good seal in order for the cooling air to circulate

properly through the chassis.

Fan speed may be controlled by a setting in BIOS (see Chapter 7).

System Fan Failure

If a fan fails, you will need to have it replaced with the same type. Contact your

vendor or Supermicro for information on replacement fans.

6-4 Drive Bay Installation/Removal

Removing the Front Bezel

If your system has a front bezel (optional) attached to the chassis, you must ﬁ rst

remove it to gain access to the drive bays. To remove the bezel, ﬁ rst unlock the

front of the chassis then press the release knob (see Figure 6-3). Carefully re-

move the bezel with both hands. A ﬁ lter located within the bezel can be removed

for replacement/cleaning. It is recommended that you keep a maintenance log of

ﬁ lter cleaning/replacement, since its condition will affect the airﬂ ow throughout the

whole system.

Figure 6-3. Removing the Front Bezel

1. Unlock

2. Press release knob

3. Remove bezel assembly