Datasheet

Chapter 6: Advanced Chassis Setup
6-7
6-5 Power Supply
The SuperServer 6015C-M3/6015C-MT has a single 520 watt power supply. This
power supply has the capability of operating at 100 - 240 input volts. Depress the
main power button on the front of the chassis and then unplug the AC power cord
to completely remove power from the system before removing the power supply.
Power Supply Failure
If the power supply module fails, the system will shut down and you will need to
replace it. Replacement modules can be ordered directly from Supermicro (PWS-
521-1H - see contact information in Chapter 1).
Replacing the Power Supply
Removing the power supply
First power down the system and unplug the AC power cord from the server.1.
Remove the top chassis cover by releasing the retention screws that secure 2.
the module to the rack, then grasp the two handles on either side and pull the
module straight out until it locks (you will hear a "click").
Next, depress the two buttons on the top of the chassis to release the top 3.
cover and push it away from you.
Lift the top cover from the chassis to gain full access to the inside of the 4.
server.
To remove the failed power module, remove the two screws on the back of 5.
the power supply, which secure it to the chassis.
You can then lift the module straight out of the chassis. (The power cord 6.
should have already been removed.)
Installing a New Power Supply
Replace the failed power supply with another identical power supply module.1.
Carefully insert the new module into position in the chassis and secure it with 2.
the two screws at the rear of the module.
Make sure the power switch on the power supply is in the off position.3.