Datasheet

1-3
Chapter 1: Introduction
ATI Graphics Controller
The X7DCU features an integrated ATI video controller based on the ES1000 graph-
ics chip. The ES1000 was designed specifi cally for servers, featuring low power
consumption, high reliability and superior longevity.
Other Features
Other onboard features that promote system health include onboard voltage moni-
tors, a chassis intrusion header, auto-switching voltage regulators, chassis and CPU
overheat sensors, virus protection and BIOS rescue.
1-3 Server Chassis Features
The 6015C-UR/6015C-NTR is built upon the SC815TQ-R650U chassis while the
6015C-U/6015C-NT is built upon the SC815TQ-560U chassis. The following is a
general outline of the main features of both chassis.
System Power
The SC815TQ-R650U features a redundant 650W power supply consisting of two
power modules. The system does not need to be shut down when replacing or
removing a single power supply module.
The SC815TQ-560U features a single 560W power supply module. The system
must be shut down when replacing or removing this power supply module.
SATA Subsystem
The SC815TQ-R650U/SC815TQ-560U chassis was designed to support four
hot-swap SATA hard drives. Note: In the 6015C-NTR/6015C-NT, SATA drives are
connected to the onboard SATA ports.
PCI Expansion Slots
6015C-UR/6015C-U: A riser card on the right side of the chassis can support one
PCI-E x8 card. The left side supports a UIO card and one PCI-E x8 card. These two
systems can support four SAS/SATA drives with an optional UIO SAS card. See our
web site for details (http://www.supermicro.com/products/nfo/UIO.cfm).
6015C-NTR/6015C-NT: A riser card on the right side of the chassis can support
one PCI-E x8 card. The left side supports two PCI-E x8 cards. See section 5-6 for
details. (Right and left refer to the side when viewed from the front of the system.
The 6015C-NTR/6015C-NT does not support a UIO card.)