Datasheet

5-20
S
UPERSERVER 6015C-UR/6015C-U/6015C-NTR/6015C-NT User's Manual
LAN Enable/Disable
Change the setting of jumper JPL1 to
enable or disable the onboard Ether-
net (RJ45) ports LAN1 and LAN2. See
the table on the right for jumper set-
tings. The default setting is enabled.
Watch Dog Enable/Disable
JWD controls the Watch Dog function.
Watch Dog is a system monitor that
can reboot the system when a software
application “hangs”. Pins 1-2 will cause
WD to reset the system if an applica-
tion hangs. Pins 2-3 will generate a
non-maskable interrupt signal for the
application that has hung. See the table
on the right for jumper settings. Watch
Dog must also be enabled in BIOS.
Note: When enabled, the user needs to
write their own application software to
disable the Watch Dog Timer.
LAN Enable/Disable
Jumper Settings (JPL1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
Compact Flash Master/Slave Select
A Compact Flash Master (Primary)/Slave
(Secondary) Select Jumper is located at
JCF1. Close this jumper to enable Com-
pact Flash Card. For the Compact Flash
Card or the Compact Flash Jumper
(JCF1) to work properly, you will need to
connect the Compact Flash Card power
cable to JWF1 fi rst. Refer to the board
layout below for the location.
Compact Flash Card Master/
Slave Select (JCF1)
Jumper Defi nition
Open Slave (Secondary)
Closed Master (Primary)
VGA Enable/Disable
JIDE allows you to enable or disable the
IDE connector. The default position is on
pins 1 and 2 to enable IDE. See the table
on the right for jumper settings.
IDE Enable/Disable
Jumper Settings (JIDE)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled