User`s manual

5-28
SUPERSERVER 7046GT-TRF/7046GT-TRF-TC4 User's Manual
FP USB Wake-up En-
able (JPUSB2)
Jumper Settings
Pin# Defi nition
1-2 Enabled
2-3 Disabled (Default)
Backpanel USB Wake-
Up Enable (JPUSB1)
Jumper Settings
Pin# Defi nition
1-2 Enabled (default)
2-3 Disabled
USB Wake-Up
JPUSB1/JPUSB2 jumpers allow you to
"wake up" the system by pressing a key on
the USB keyboard or by clicking the USB
mouse of your system. JPUSB1 is used for
Backpanel USB Ports #0~5, and JPUSB2
is for Front Panel USB Ports #6~9. These
jumpers are used in conjunction with the
USB Wake-Up function in the BIOS. See
the table on the right for jumper settings
and jumper connections. (JPUSB1: Default:
Enabled, JPUSB2: Default: Disabled.)
Alarm Reset
Jumper Settings
Pin Setting Defi nition
Closed Alarm Reset
Open Normal
Alarm Reset
If three power supplies are installed and
Alarm Reset (JPRST1) is enabled, the sys-
tem will notify you when any of the three
power modules fails. Connect JPRST1 to
a micro-switch to enable you to turn off
the alarm that is activated when a power
module fails. See the table on the right for
jumper settings.
Audio Enable/Disable
Jumper Settings (JPG1)
Both Jumpers Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
Audio Enable
JPAC allows you to enable or disable the
onboard audio connection. The default
position is on pins 1 and 2 to enable audio
support. See the table on the right for jumper
settings.
TPM Enable
Jumper Settings
Jumper Setting Defi nition
1~2 Enabled (Default)
2~3 Disabled
TPM Support Enable
JPT1 allows the user to enable TPM (Trusted
Platform Modules) support to enhance data
integrity and system security. See the table
on the right for jumper settings. The default
setting is enabled. (This feature is available
for the OEM only.)`