User`s manual

6-12
SUPERSERVER 7046GT-TRF/7046GT-TRF-TC4 User's Manual
Adding Peripheral Drives
You can add up to three peripheral drives (DVD-ROM, CD-ROM, fl oppy drive, etc.)
to the drive trays using the procedure below.
Adding Peripheral Drives
Open the chassis cover.1.
Locate the drive tray release tab for the slot you want to place the peripheral 2.
drive.
Push the drive tray toward the front of the chassis.3.
Remove the hard drive tray rails from the hard drive tray. To do this, you must 4.
remove two screws from each side (see Figure 6-12).
Attach the rails to a DVD-ROM, CD-ROM, fl oppy drive, or other peripheral. 5.
The rails should fi t any standard sized peripherals.
Slide the peripheral into the chassis until the tray clicks into place.6.
Repeat these steps for each hard drive tray.7.
Hard Drive Rails
Hard Drive Tray
Figure 6-12: Adding Hard Drive Rails to the DVD-ROM Drive