Datasheet

Chapter 6: Advanced Chassis Setup
6-3
6-2 Front Control Panel
The front control panel must be connected to the JF1 connector on the serverboard
to provide you with system status and alarm indications. A ribbon cable has bundled
these wires together to simplify this connection. Connect the cable from JF1 on
the serverboard (making sure the red wire plugs into pin 1) to the appropriate
comnnector on the front control panel PCB (printed circuit board). Pull all excess
cabling over to the control panel side of the chassis. The LEDs on the control
panel inform you of system status -See Figure 6-2 for details. See Chapter 5 for
details on JF1.
Figure 6-2. Front Control Panel LEDs
Power
NIC1
HDD
Power Fail
Overheat/Fan Fail
Indicates power is being supplied to the system.
Indicates network activity on LAN port 1.
Indicates IDE device and hard drive activity. On the
SC745TS-920NBP, this LED indicates SATA hard drive
activity when fl ashing.
Indicates a power supply failure. This LED is functional
only when two power supply modules are installed in the
system.
When this LED fl ashes, it indicates a fan failure. When
on continuously it indicates an overheat condition (see
Chapter 3 for details).
NIC2 Indicates network activity on LAN port 2
1
2