Datasheet

Chapter 5: Advanced Serverboard Setup
5-9
To Install: Insert module vertically and press down until it snaps into place. Pay attention to the bottom
notches.
To Remove: Use your thumbs to gently push each release tab outward to free the DIMM from the
slot.
Figure 5-4. DIMM Installation
5-7 Adding PCI Add-On Cards
The 8015C-T can accommodate one PCI-Express x8 card with the use of the CSE-
RR1U-E16 riser card inserted into the PCI-E x16 slot.
Installing an Add-on Card
Begin by removing the PCI slot shield for the slot you wish to populate.
Fully seat the card into the riser card slot, pushing down with your thumbs
evenly on both sides of the card.
Finish by using a screw to secure the top of the card shield to the chassis.
The PCI slot shields protect the serverboard and its components from EMI
and aid in proper ventilation, so make sure there is always a shield covering
each unused slot.
1.
2.
3.
DDR2 FBD DIMM