User's Manual (1.0b)

2-12
X10QBi Platform User's Manual
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage. Check Supermicro's
website for recommended memory modules.
Installing DIMM Modules on the X10QBi Memory Card
Release Tabs
Notches
Note: Press the memory
straight down into the slot until
it is properly seated, and the
Present_LED is on. Be sure
to always populate the blue
slots rst, starting with DIMMA1,
DIMMB1, DIMMC1, and then
DIMMD1.
1. Install the desired number of DIMM modules on a memory card; each
card supports up to 12 DIMMs. When installing memory, be sure to always
populate the blue slots rst, starting with DIMMA1, DIMMB1, DIMMC1, and
DIMMD1. For best performance, please use the memory modules of the
same type and same speed in the same bank.
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module with the receptive points on the
ends of the slot. Use two thumbs together to press module straight down into
the slot until the module snaps into place and the PRESENT_LED (as shown
above) is on.
5. Press the release tabs to the lock positions to lock the DIMM module into the
slot
X10QBi-MEM1
PRESENT_LED1
DIMM2A_LED3
DIMM1A_LED2
DIMM0A_LED1
DIMM2B_LED6
DIMM1B_LED5
DIMM0B_LED4
DIMM2C_LED1 DIMM1C_LED8
DIMM0C_LED7
DIMM2D_LED4
DIMM1D_LED3
DIMM0D_LED2
BAR CODE
A3
D1D2C1C2C3 D3
OK
B1B2B3A1A2
JDI
JDI
DIMMC3
DIMMA1 DIMMA2
DIMMA3
DIMMB3
DIMMB2
DIMMB1
Rev. 1.01
DIMMC2
DIMMC1
DIMMD3
DIMMD2
DIMMD1
A1
A2
A3
B1
B2
B3
C1
C3
D1
D2
D3
DIMM C3
C2
DIMM C2
DIMM C1
DIMM D3
DIMM D2
DIMM D1
DIMM A3
DIMM A2
DIMM A1
DIMM B3
DIMM B2
DIMM B1
PRESENT_LED