User's Manual (1.0b)

Chapter 2: Installation
2-15
X10QBi
Rev:1.02
MAC CODE
BAR CODE
MAC CODE
2-5 Installing the System Motherboard into the Chassis
Follow the instructions below to install the system motherboard into the chassis.
Tools Needed
•Phillips Screwdriver
•Pan_head #6 screws (19 pieces)
•Standoffs (19 pieces, if needed)
1. Install the I/O shield into the chassis.
2. Locate the mounting holes on the system system board and the matching
mounting holes on the chassis.
3. Place the system board into the chassis, making sure that the mounting holes
on the system board match the corresponding mounting holes on the chassis.
4. Install standoffs in the chassis as needed.
5. Using the Phillips screwdriver, insert a pan head #6 screw into a mounting
hole on the system board and its matching mounting hole on the chassis.
Repeat this step for other mounting holes to secure the system board to the
chassis.