User's Manual (1.0b)

Chapter 2: Installation
2-21
SW1
LED28
JPB1
JPG1
JPL1
AOM-X10QBi-A
Rev. 1.00
SWUID1
JEDUID1
JCOM1
JLAN3
JLAN2 JLAN1
JVGA1
JVGA2
LAN CTRL
BMC
Power Button
Red (OH/Fan Fail/
PWR FaiL)
1
NIC1 Link LED
Reset Button
2
Power Fail LED
HDD LED
FP PWRLED
Reset
PWR
3.3V
3.3V
Blue Led Cathode
(UID)
Ground
Ground
1920
3.3V
X
Ground
NMI
X
NIC2 Link LED
NIC2 Active LED
NIC1 Active LED
Unit Identier Switch/LEDs (On the I/O
Module)
A Unit Identier (UID) switch on the AOM-
X10QBi-A I/O module, and two LED indica-
tors are located on the baseboard. The UID
switch is located next to the LAN ports on
the I/O module. The rear UID LED (LED28)
is located next to the UID switch. The front
panel UID LED is located at pins 7/8 of the
Front Control Panel at JF1. Connect a cable
to pins 7/8 on JF1 for front panel UID LED
indication. When you press the UID switch,
both rear UID LED and front panel UID LED
indicators will be turned on. Press the UID
switch again to turn off both LED indicators.
These UID indicators provide easy identica-
tion of a system unit that may be in need of
service.
Note: UID can also be triggered
via the IPMI on the system moth-
erboard. For more information on
the IPMI, please refer to the IPMI
User's Guide posted on our website
@http://www.supermicro.com.
UID Switch
Pin# Denition
1 Ground
2 Ground
3 Button In
4 Ground
A. UID Switch
B. Rear UID LED (LED28)
C. Front UID LED
UID LED (LED28)
Status
Color/State OS Status
Blue: On Windows OS Unit Identied
Blue:
Blinking
Linux OS Unit Identied
AOM-X10QBi-A I/O Module
A
C
B
A