User Manual
Table Of Contents
- Preface
- Chapter 1 Introduction
- Chapter 2 Installation
- 2-1 Standardized Warning Statements
- 2-2 Static-Sensitive Devices
- 2-3 Motherboard Installation
- 2-4 Memory Support
- 2-5 Connectors/IO Ports
- 2-6 Connecting Cables
- ATX PWR, DC PWR and HDD PWR Connectors (JPW1, PJ1, J6)
- Fan Headers (FAN1 ~ FAN4) (FAN4 is available on PCB 2.00 only)
- Chassis Intrusion
- System Management Bus Header
- DOM PWR Connector
- TPM Header/Port 80 Header
- Overheat LED Header
- Speaker
- Standby Power
- I-SGPIO1/I-SGPIO2
- NVMe I2C Header
- Power SMBus (I2C) Connector (available on PCB 2.00 only)
- System Management Bus Header
- GPIO Header
- ATX PWR, DC PWR and HDD PWR Connectors (JPW1, PJ1, J6)
- 2-7 Jumper Settings
- 2-8 Onboard Indicators
- 2-9 SATA Connections
- Chapter 3 Troubleshooting
- Chapter 4 BIOS
- Appendix A BIOS Error Beep Codes
- Appendix B Software Installation Instructions
- Appendix C UEFI BIOS Recovery Instructions
- Appendix D Dual Boot Block
Chapter 1: Introduction
1-11
JSMB1 SMBus Header
JSTBY1 Standby Power Header
JTPM1 Trusted Platform Module (TPM)/Port 80 Connector
JUIDB1 Unit Identier (UID) Button
LAN1 ~ LAN2
LAN3 ~ LAN4
Gigabit Ethernet (RJ45) Ports (Not available on TLN2F)
10G Ethernet (RJ45) Ports (TLN4F and TLN2F only)
PJ1 4-pin 12V DC Power Connector (To provide alternative
power for special enclosure when the 24-pin ATX power is
not in use.)
SLOT7 PCI-E 3.0 X16 Slot
SRW1, SRW2 M.2 Holding Screws
USB 0/1 Back panel USB 3.0 Ports
USB2/3, USB4/5 Front Access USB 2.0 Ports
VGA Back panel VGA Port
LED Indicators
LED Description Color/State Status
LEDM1 BMC Heartbeat LED Green: Blinking BMC: Normal
LED3 Power LED Green: On System Power On
LED7 UID Switch LED Blue: On Unit Identied
LED8 Overheat/PWR Fail/Fan Fail
LED
Red: Solid on
Blinking
Solid On: Overheat,
Blinking: PWR Fail or
Fan Fail