User Manual
Table Of Contents
- Preface
- Chapter 1 Introduction
- Chapter 2 Installation
- 2-1 Standardized Warning Statements
- 2-2 Static-Sensitive Devices
- 2-3 Motherboard Installation
- 2-4 Memory Support
- 2-5 Connectors/IO Ports
- 2-6 Connecting Cables
- ATX PWR, DC PWR and HDD PWR Connectors (JPW1, PJ1, J6)
- Fan Headers (FAN1 ~ FAN4) (FAN4 is available on PCB 2.00 only)
- Chassis Intrusion
- System Management Bus Header
- DOM PWR Connector
- TPM Header/Port 80 Header
- Overheat LED Header
- Speaker
- Standby Power
- I-SGPIO1/I-SGPIO2
- NVMe I2C Header
- Power SMBus (I2C) Connector (available on PCB 2.00 only)
- System Management Bus Header
- GPIO Header
- ATX PWR, DC PWR and HDD PWR Connectors (JPW1, PJ1, J6)
- 2-7 Jumper Settings
- 2-8 Onboard Indicators
- 2-9 SATA Connections
- Chapter 3 Troubleshooting
- Chapter 4 BIOS
- Appendix A BIOS Error Beep Codes
- Appendix B Software Installation Instructions
- Appendix C UEFI BIOS Recovery Instructions
- Appendix D Dual Boot Block
1-14
X10SDV Mini-ITX Series Motherboard User’s Manual
System Block Diagram
Note: This is a general block diagram and may not exactly represent
the features on your motherboard. See the Motherboard Features
pages for the actual specications of each motherboard.
LPC
USB
PCI-E 2.0
LAN
PCIE 2.0 x4
USB 3.0
CPU
i350
COM1
DDR 3
BMC
AST2400
PHY
RTL8211E
VGA CONN
IPMI LAN
SPI
FLASH
USB 2.0
SATA3.0#2
SATA3.0#6
SATA3.0#3
SATA3.0#4
SATA3.0#5
SATA3.0#1
JPCIE1
PCIE 3.0 x16
M.2 connector
PCIE 3.0 x4
or SATA 3.0 x1
DDR4 DIMM
B1
DDR4 DIMM
A2
A
B
A1
DDR4 DIMM
A
DDR4 DIMM
B1
B
SATA GEN 3
(SATA DOM)
SWITCH
SWITCH
PCIE 3.0 x1
PCIE 3.0 x16
SATA Gen3
PCI-E 3.0
PCI-E 3.0
PCI-E 3.0
PCIE 2.0 x1
USB HUB
GL852G
USB 3.0 connector x2
(compatible with 2.0)
USB 2.0 Header x2
LAN KR
10G Base-T
PHY
x2
x1
x1
VGA
USB3.0
1G LAN 10G LAN
PCIE 3.0 x3
USB 2.0 Header x2
Dedicated IPMI Port
+
KR
TLN2F and TLN4F only
TLN2F and TLN4F only
REAR IO
X10SDV Mini-ITX Series Block Diagram