User Manual
Table Of Contents
- Preface
- Chapter 1 Introduction
- Chapter 2 Installation
- 2-1 Standardized Warning Statements
- 2-2 Static-Sensitive Devices
- 2-3 Motherboard Installation
- 2-4 Memory Support
- 2-5 Connectors/IO Ports
- 2-6 Connecting Cables
- ATX PWR, DC PWR and HDD PWR Connectors (JPW1, PJ1, J6)
- Fan Headers (FAN1 ~ FAN4) (FAN4 is available on PCB 2.00 only)
- Chassis Intrusion
- System Management Bus Header
- DOM PWR Connector
- TPM Header/Port 80 Header
- Overheat LED Header
- Speaker
- Standby Power
- I-SGPIO1/I-SGPIO2
- NVMe I2C Header
- Power SMBus (I2C) Connector (available on PCB 2.00 only)
- System Management Bus Header
- GPIO Header
- ATX PWR, DC PWR and HDD PWR Connectors (JPW1, PJ1, J6)
- 2-7 Jumper Settings
- 2-8 Onboard Indicators
- 2-9 SATA Connections
- Chapter 3 Troubleshooting
- Chapter 4 BIOS
- Appendix A BIOS Error Beep Codes
- Appendix B Software Installation Instructions
- Appendix C UEFI BIOS Recovery Instructions
- Appendix D Dual Boot Block
1-16
X10SDV Mini-ITX Series Motherboard User’s Manual
1-3 Special Features
Recovery from AC Power Loss
Basic IO System (BIOS) provides a setting for you to determine how the system will
respond when AC power is lost and then restored to the system. You can choose for
the system to remain powered off, (in which case you must press the power switch
to turn it back on), or for it to automatically return to a power-on state. See the Ad-
vanced BIOS Setup section to change this setting. The default setting is Last State.
1-4 PC Health Monitoring
This section describes the PC health monitoring features of the board. All have
an onboard System Hardware Monitoring chip that supports PC health monitoring.
An onboard voltage monitor will scan these onboard voltages continuously: +1.8V,
+3.3V, +5V, +/-12V, +3.3V Stby, +5V Stby, VBAT, HT, Memory, PCH Temperature,
System Temeperature, and Memory Temperature. Once a voltage becomes un-
stable, a warning is given, or an error message is sent to the screen.
Environmental Temperature Control
Some X10SDV models come with an active heatsink built in while others come
with a passive heatsink for rackmount systems that are chassis-fan optimized (refer
to the model variation tables on page 1-9). Please follow the instructions given in
your system design guide or your system user manual to provide adequate airow
to your system. The onboard BaseBoard Management Controller (BMC) monitors
CPU, memory and motherboard environment temperatures for fan control and PC
health management.
Note: To avoid possible system overheating, please be sure to provide
adequate airow to your system.
System Resource Alert
This feature is available when the system is used with SuperDoctor
®
5 in the
Windows and Linux operating systems. SuperDoctor is used to notify the user
of certain system events. For example, you can also congure SuperDoctor to
provide you with warnings when the system temperature, CPU temperatures,
voltages and fan speeds go beyond predened thresholds.