Datasheet
D-14
X6DAL-G/X6DAL-TG User's Manual
When expanded, the Full Size Capacity View button and the Relative
Size Capacity View button represent each drive as a bar. A drive that
is not used as part of any array is shaded blue surrounded by a dotted line.
displays a full-length bar for each drive, regardless of capacity.
displays a bar for each drive, with the largest capacity drive full-length
and the other drives proportional to the drive capacity, relative to the largest
drive.
Any part of a drive used in an array is shown as a gray segment within the
bar. Selecting any gray segment will highlight it in amber, and in the Logical
Devices view, highlight the array of which this segment is a member.
In either the Full Size Capacity View or the Relative Size Capacity View, a small
portion at each end of the drive may be shown in dark gray.
The segment at the end of the drive may vary in size from drive to drive
because, in addition to the RAID signature, the controller may also limit the
usable capacity of each drive.
This is done because hard disk drives of apparently the same capacity from
different manufacturers, or even different models from the same manufacturer,
actually vary slightly in the true capacity available. Although, in normal operation
this is not an issue, it can be when assigning hot spares or replacing a failed
drive.
If the controller used the maximum capacity of each drive and a hot spare or
replacement drive was just a few megabytes smaller, it would not be able to
replace the failed drive. By rounding drive capacities down to the nearest 2
MB, this possibility is effectively eliminated.
Logical Devices
As described earlier, when Adaptec Storage Manager loads, the Logical
Devices view is expanded and you can see the arrays present on the
controller.
At the top of this view are the following buttons: Create, Modify, and Delete.
Each button opens a wizard for the corresponding function.
Modify allows you to:
* Change an array from one RAID level to another
* Expand an array
* Change the stripe size for a RAID 0
In this condensed view, the RAID level of each device, as well as whether it is
protected by a hot spare, is visible.