Computer Hardware User Manual

Chapter 4: AMI BIOS
4-13
SMBIOS Confi guration
SMBIOS SMI Support
Select Enabled to enable the function of SMBIOS SMI Wrapper support for PnP
Func 50h-54h. The options are Enabled and Disabled.
Remote Access Confi guration
You can use this screen to select options for the Remote Access Confi guration.
Use the up and down arrow keys to select an item. Use the <+> and <-> keys to
change the value of the selected option.
Remote Access
This feature allows the user to enable the function of Remote Access. The options
are Enabled and Disabled.
If the item "Remote Access" is set to Enabled, you can select a Remote Access
type and confi gure the following settings:
Serial Port Number
This feature allows the user to select the serial port for Console Redirection.
The options are COM1 and COM2.
Base Address
This feature allows the user to set Base Address for the Serial Port Selected.
The default setting is 2F8h, 8.
Serial Port Mode
This feature allows the user to set the serial port mode for Console Redirection.
The options are 115200 8, N, 1, 57600 8, N, 1, 38400 8, N, 1, 19200 8, N, 1
and 9600 8, N, 1.
Flow Control
This feature allows the user to set the fl ow control for Console Redirection. The
options are None, Hardware, and Software.
Redirection After BIOS POST
This feature allows the user to select Disabled to turn off Console Redirection after
POST. Select Always to keep Console Redirection active all the time. (*Note: this
setting may not be supported by some operating systems.) Select Boot Loader
to keep Console Redirection active during POST and Boot Loader.