Computer Hardware User Manual

4-14

X6QT8/X6QTE+ User’s Manual

Terminal Type

This feature allows the user to select the target terminal type for Console

Redirection.The options are ANSI, VT100, and VT-UTF8.

VT-UTF8 Comb Key Support

This feature allows the user to select Enabled to enable the VT-UTF8 Combination

Key support for the ANSI/VT100 Terminals. The options are Enabled and

Disabled.

Sredir Memory Display Delay

This feature allows the user to decide how many seconds the BIOS shall wait

before memory information is displayed. The options are: No Delay, Delay 1

Sec., Delay 2 Sec. and Delay 4 Sec.

USB Conﬁ guration

This feature allows the user to conﬁ gure the USB settings.

USB Function

This feature allows you to enable the USB Ports. The options are Disabled, 2

USB Ports, 4 USB Ports, and Enabled.

Legacy USB Support

Select Enabled to enable USB Legacy support. Disable legacy support if there

are no USB devices installed in the system. The options are Disabled, Enabled,

and Auto.

USB 2.0 Controller

This setting allows you to enable or disable the USB 2.0 Controller. The options

are Disabled and Enabled.

USB 2.0 Controller Mode

This setting allows you to conﬁ gure the USB 2.0 Controller Mode. The options are

Hi-Speed (480 Mbps) and Full Speed-(12Mbps).

Stop EHCI HC in OHCI Handover

Select Enabled to halt an ECHI Host Controller during OHCI OS handover calls

when the EHCI Host Controller is not supported by the Operating System.

Hot Plug USB FDD Support

Set to Enabled to create a dummy FDD device to be used as a hot-plug FDD.

Set to Auto for a hot-plug FDD device to be automatically created if a USB FDD

is not detected. The options are Auto, Enabled and Disabled.