User's and BIOS Manual (1.2)

Chapter 2: Installation
2-23
®
JLAN1
S
UPE R
X7DB
3
A
A. Compact Flash PWR
B. SGPIO1
C. SGPIO2
Compact Flash Card PWR
Connector
A Compact Flash Card Power
Connector is located at JWF1. For the
Compact Flash Card or the Compact
Flash Jumper (JCF1) to work properly,
you will need to connect the Compact
Flash Card power cable to JWF1 fi rst.
Refer to the board layout below for
the location.
Compact Flash Card PWR
Connector
Jumper Defi nition
On Compact Flash
Power On
Off Compact Flash
Power Off
C
B
SGPIO Headers
There are two SGPIO (Serial General
Purpose Input/Output) headers (J29,
J30) located on the motherboard.
These headers support serial link
interfaces for the onboard ESB2 SATA
connectors. See the table on the right
for pin defi nitions. Refer to the board
layout below for the location.
PWR SMB
Pin Defi nitions
Pin# Defi nition Pin Defi nition
1 *NC 2 *NC
3 Out 4 *NC
5 Ground 6 Load
7 *NC 8 Clock
Note: NC= No Connections