Datasheet

Chapter 2: Installation
2-3
Socket Key
(Socket Notch)
South Center Edge
North Center Edge
Socket clip
CPU in the CPU socket
Plastic cap
is released
from the
load plate
if the CPU
is properly
installed.
3. Use your thumb and your index
fi nger to hold the CPU at the North
Center Edge and the South Center
Edge of the CPU.
4. Align CPU Pin1 (the CPU corner
marked with a triangle) against the
socket corner that is marked with a
triangle cutout.
5. Align the CPU key that is the semi-
circle cutout below a gold dot against
the socket key, the Notch on the
same side of the triangle cutout on
the socket.
6. Once aligned, carefully lower the
CPU straight down into the socket.
(**Do not drop the CPU on the socket.
Do not move the CPU horizontally or
vertically. Do not rub the CPU against
the surface or against any pins of the
socket to avoid damage to the CPU
or the socket.)
7. With the CPU inside the socket,
inspect the four corners of the CPU
to make sure that the CPU is properly
installed.
8. Use your thumb to gently push the
socket clip down to the clip lock.
9. If the CPU is properly installed into
the socket, the plastic cap will be
automatically released from the load
plate when the clip is pushed in the
clip lock. Remove the plastic cap from
the motherboard.
*Warning: Please save the
plastic cap. The motherboard must be
shipped with the plastic cap properly
installed to protect the CPU socket
pins. Shipment without the plastic cap
properly installed will cause damage
to the socket pins.
!
CPU Key (semi-
circle cutout)
below the circle.
CPU Pin1
Corner with a
triangle cutout
gold dot