User's and BIOS Manual (1.0c)

1-2
S
UPERSERVER 6015P-T(R)/6015P-8(R) User's Manual
1-2 Serverboard Features
At the heart of the SuperServer 6015P-T(R)/6015P-8(R) lies the X7DBP-i/X7DBP-8,
a dual processor serverboard based on the Intel 5000P chipset and designed to pro-
vide maximum performance. Below are the main features of the X7DBP-i/X7DBP-8.
(See Figure 1-1 for a block diagram of the Intel 5000P chipset.)
Processors
The X7DBP-i/X7DBP-8 supports single or dual Intel dual-core Xeon 5100/5000
series processors. Please refer to the serverboard description pages on our web
site for a complete listing of supported processors (www.supermicro.com).
Memory
The X7DBP-i/X7DBP-8 has eight 240-pin DIMM slots that can support up to 32
GB of ECC FBD (Fully Buffered DIMMs) DDR2-667 or DDR2-533 SDRAM. The
memory is an interleaved confi guration, which requires modules of the same size
and speed to be installed in pairs.
Serial ATA (SATA)
A SATA controller is integrated into the South Bridge of the 5000P chipset to
provide a six-port Serial ATA subsystem, which is RAID 0, 1, 10 and 5 supported.
The Serial ATA drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the Serial ATA drives.
Onboard SCSI (6015P-8/6015P-8R only)
An onboard Adaptec AIC-7902 dual-channel SCSI controller in integrated into the
X7DBP-8, which supports 80-pin SCA Ultra320 SCSI hard drives. (Standard 1"
drives are supported. SCA = Single Connection Attachment.) The SCSI drives are
connected to an SCA backplane that provides power, bus termination and confi gura-
tion settings. The SCSI drives are hot-swappable units.
Note: The operating system you use must have RAID support to enable the hot-
swap capability and RAID function of the SCSI drives.