User's and BIOS Manual (1.0c)

Chapter 5: Advanced Serverboard Setup
5-11
X7DBP-8/X7DBP-i Quick Reference
Jumper Description Default Setting
JBT1 CMOS Clear (See Section 5-9)
JCF1 IDE#1 Compact Flash M/Slave Select Closed (Master)
JCF2 IDE#2 Compact Flash M/Slave Select Open (Slave)
JI
2
C1/JI
2
C2 SMBus to PCI-X/E Slots En/Disable Open (Disabled)
JPA1* SCSI Controller Enable/Disable Pins 1-2 (Enabled)
JPA2/JPA3* SCSI ChA/ChB Termination En/Dis Open (Enabled)
JPG1 VGA Enable/Disable Pins 1-2 (Enabled)
JPL1/ JPL2 JLAN1/JLAN2 Enable/Disable Pins 1-2 (Enabled)
JWD Watch Dog Pins 1-2 (Reset)
Connector Description
COM1/COM2 COM1/COM2 Serial Port/Header
FAN 1-10** Fan Headers 1-10
IDE#1 IDE Hard Drive Connector
IDE#2 Compact Flash Card Connector
J18 System Management Bus Header
JA1/JB1* SCSI Channel A & B Connectors
JF1 Front Control Panel Connector
JFDD1 Floppy Disk Drive Connector
JL1 Chassis Intrusion Header
JOH1 Overheat LED
JPB1 UID (Unit Identifi er) Button/LED
JPWR1 Auxiliary Power Connector
JRST1 Alarm Reset
JUSB2/JUSB3 Extra USB Headers (JUSB2/3 and JUSB4)
JWF1 Compact Flash Card Power Connector (for IDE#1)
JWF2 Compact Flash Card Power Connector (for IDE#2)
JWOL Wake-on-LAN Header
JWOR Wake-on-Ring Header
JWR1 Primary 20-Pin ATX Power Connector (Proprietary)
LAN1/2 G-bit Ethernet Ports
ISATA0~5 Intel Serial ATA Ports/Connectors
SIM 1U IPMI IPMI Connector
USB0/1 USB Ports
*X7DBP-8 only
**Proprietary fan headers; each header has 6 pins and supports two fans.