User's and BIOS Manual (1.0c)

5-12
S
UPERSERVER 6015P-T(R)/6015P-8(R) User's Manual
Power LED
The Power LED connection is located
on pins 15 and 16 of JF1. Refer to the
table on the right for pin defi nitions.
NMI Button
The non-maskable interrupt button
header is located on pins 19 and 20
of JF1. Refer to the table on the right
for pin defi nitions.
NMI Button
Pin Defi nitions (JF1)
Pin# Defi nition
19 Control
20 Ground
Power LED
Pin Defi nitions (JF1)
Pin# Defi nition
15 Vcc
16 Control
5-8 Connecting Cables
Primary ATX Power
Connector
The primary power supply connector
(JWR1) is a proprietary design with
unique pinouts and requires the cor-
rect proprietary power supply to oper-
ate. Refer to the table on the right for
the pin defi nitions of the JWR1 main
power connector. You must also con-
nect the JPWR1 power connector to
your power supply (see below).
Required Connection
Auxiliary Power Connector
In addition to the Primary ATX power
connector (above), the 10-pin power
connector at JPWR1 must also be
connected to your power supply. See
the table on the right for pin defi ni-
tions. Note that the pin arrangement
is different than usual, with pins 1 and
2 on opposite sides.
Secondary Power Connector
Pin Defi nitions (JPWR1)
Pin# Defi nition Pin # Defi nition
1 SMBus I
2
C Clock 2 Ground
3 SMBus I
2
C Data 4 Power Fail
5 Ground 6 Power Good
7 Power On 8 -12V
9 NC 10 No pin
Required Connection
ATX Power 20-pin Connector
Pin Defi nitions (JWR1)
Pin# Defi nition Pin # Defi nition
11 Ground 1 Ground
12 +5V 2 Ground
13 +5V 3 Ground
14 +3.3V 4 Ground
15 +3.3V 5 Ground
16 +5VSB 6 Ground
17 +12V 7 Ground
18 +12V 8 +12V
2
19 +12V
1
9 +12V
2
20 NC 10 +12V
1