User's and BIOS Manual (1.0c)

5-20
S
UPERSERVER 6015P-T(R)/6015P-8(R) User's Manual
SCSI Controller Enable/
Disable (6015P-8R/8 only)
Jumper JPA1 is used to enable or dis-
able the onboard SCSI controller. The
default setting is on pins 1-2 to enable
SCSI. See the table on the right for
jumper settings.
SCSI Enable/Disable
Jumper Settings (JPA1)
Both Jumpers Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SCSI Termination Enable/
Disable (6015P-8R/8 only)
Jumpers JPA2/JPA3 are used to en-
able or disable termination for the
SCSI Channel A (JPA2) and Channel B
(JPA3) connectors. The default setting
is open to enable termination. See the
table on the right for jumper settings.
Note: In order for the SCSI drives to
function properly, please do not change
the default setting (enabled) set by the
manufacturer.
SCSI Term. Enable/Disable
Jumper Settings (JPA2/JPA3)
Jumper Setting Defi nition
Open Enabled
Closed Disabled
SMBus to PCI Slots
Jumpers JI
2
C1 and JI
2
C2 allow you
to connect
the PCI-X/PCI-E slots to
the System Management Bus
. The
default setting is open to disable the
connection. See the table on the right
for jumper settings.
SMBus to PCI
Jumper Settings (JI
2
C1, JI
2
C2)
Jumper Setting Defi nition
Closed Enabled
Open Disabled