User's and BIOS Manual (1.0c)

6-2
S
UPERSERVER 6015P-T(R)/6015P-8(R) User's Manual
Figure 6-1. Chassis: Front and Rear Views
UID Button and LED
6-2 Control Panel
The control panel (located on the front of the chassis) must be connected to the
JF1 connector on the serverboard to provide you with system status indications. A
ribbon cable has bundled these wires together to simplify the connection. Connect
the cable from JF1 on the serverboard to the appropriate header on the Control
Panel PCB (printed circuit board). Make sure the red wire plugs into pin 1 on both
connectors. Pull all excess cabling out of the airfl ow path.
The control panel LEDs inform you of system status. See "Chapter 3: System
Interface" for details on the LEDs and the control panel buttons. Details on JF1
can be found in "Chapter 5: Advanced Serverboard Setup."
Control Panel
System LEDs Main Power
Slim DVD-ROM Drive
Slim Floppy Drive
SATA/SCSI Drives
PCI Expansion Slot Power SuppliesGLAN Ports
COM PortMouse/Keyboard PortsUSB0/1 Ports
UID Button/LED Low Profi le PCI Slot
SCSI Port
Notes: The 6015P-T/6015P-8 shares the same rear view as shown above but has a cover plate
over the second (redundant) power supply module area. An external SCSI port is available with
the 6015P-8R/6015P-8 only.
VGA Port