Computer Hardware User Manual

Chapter 2: Installation
2-33
LSI 1068E
NIC4 LED
JBMC1
SAS Enable/Disable
Jumper Settings
Jumper Settings Defi nition
Pins 1-2 Enabled (Default)
Pins 2-3 Disabled
SAS Enable/Disable (X8STi-3F Only)
JPS1 allows you to enable or disable
SAS Connectors. The default position is
on pins 1 and 2 to enable SAS. See the
table on the right for jumper settings.
SAS RAID Mode Select
Jumper Settings
Settings Defi nition
Close Software RAID Enabled (Default)
Open IT Mode Enabled
SAS RAID Mode Select (X8STi-3F
Only)
JPS2 allows you to select the SAS RAID
mode. You can use either Software RAID
or IT Mode. Close this jumper to use
Soft ware R AID (Default). Set this jumper
to open to use the IT Mode.
A
B
A. RAID Enable
B. SAS RAID Mode Se-
lect