User's Manual (1.0c)

Chapter 2: Installation
2-11
JF2
JSD1
SW1
JIPMB1
J21
JBT1
LEB1
LEB2
LE3
JI2C2
JI2C1
JNMI1
JRST1
JWD1
JPME2
JIB1
JWP1
JPL1
JPG1
JBAT1
JTPM1
P2 DIMMF1
P2 DIMME1
XDP-CPU
COM1
VGA
S-SATA0
Always DIMMxA First
CPU1_Port2 SXB1 PCI-E 3.0 x16
LAN1
IPMI_LAN
USB0/1
LAN2
USB2
P1 DIMMC1
UID
P1 DIMMD1
X9DRT-HF
Rev. 1.21
BIOS
P1 DIMMB1
FP CTRL
PWR SPPLY
PCH
IB CTRL
InfiniBand
Connector
LAN CTRL
BMC
PCI-Ex16 (Proprietary)
P2 DIMMH1
J4
LE1
LE2
JPB1
JB2
JB3
JB1
LEM1
S-SATA2
I-SATA1
I-SATA0
P1 DIMMA1
JPME1
CPU1_Port3A SXB2 PCI-E 3.0 X8
CPU2_Port2C SXB3 PCI-E 3.0 X8
S-SATA3
CLOSE 1st
OPEN 1st
CPU2
P2 DIMMG1
CPU1
CLOSE 1st
OPEN 1st
Release Tabs
Notches
2-4 Installing and Removing the Memory Modules
Note: Check Supermicro's website for recommended memory modules.
CAUTION
Exercise extreme care when installing or removing DIMM
modules to prevent any possible damage.
Installing & Removing DIMMs
1. Insert the desired number of DIMMs into the memory slots, starting with
P1-DIMMA1. (For best performance, please use the memory modules of the
same type and speed in the same bank.)
2. Push the release tabs outwards on both ends of the DIMM slot to unlock it.
Removing Memory Modules
Press the release tabs on both ends of the memory module to unlock it. Once it is
loosened, remove the DIMM module from the memory slot.
3. Align the key of the DIMM module with the receptive point on the memory
slot.
4. Align the notches on both ends of the module against the receptive points on
the ends of the slot.
5. Use two thumbs together to press the notches on both ends of the module
straight down into the slot until the module snaps into place.
6. Press the release tabs to the locking positions to secure the DIMM module
into the slot.
Press both notches straight
down into the memory slot at
the same time.