Installation Instructions

Table Of Contents

COMPLIANCE WITH FCC

REGULATIONS

FCC Statement

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates uses and can radiate radio

frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which

the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help

This device complies with part 15 of the FCC rules. Operation is subject to the

following two conditions (1)this device may not cause harmful interference,

and (2) this device must accept any interference received, including

interference that may cause undesired operation.

This equipment complies with FCC radiation exposure limits set forth for an

uncontrolled environment, In order to avoid the possibility of exceeding the

FCC radio frequency exposure limits,Human proximity to the antenna shall not

be less than 20cm (8 inches) during normal operation.

PRECAUTIONS BEFORE USE

 UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.

 DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS

VOLTAGE AND UNTIL ALL OTHER CONNECTIONS HAVE BEEN MADE.

 DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF

SEVERAL INCHES AROUND THE UNIT FOR VENTILATION.

PAGE 1
COMPLIANCE WITH FCC REGULATIONS FCC Statement Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 2
IMPORTANT NOTES  Stop operation immediately if any liquid or solid object should fall into the cabinet  If the unit is not to be used for a long period of time, make sure that all power sources are disconnected from the unit. And unplug the AC-DC adaptor from the wall outlet. Make it a practice to remove the AC-DC adaptor by grasping the plug and not by pulling the cord.  Places exposed to direct sunlight or close to heat radiating appliances such as electric heaters.
PAGE 3
 Connect the equipment in to an outlet on a circuit different from that to which the receiver is connected  Consult the dealer or an experienced radio/TV technician for help PROTECT YOURSELF! Record the model and serial numbers for this unit while it is easy to see them. These numbers are located on the back of the unit's cabinet. Retain this information for future reference. CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK).