Use and Care Manual

lp-83 Rev. 12.5.16

Part 4 - Heater Control and Wiring

A. Control

Install control element into the control well and tighten into place with screws on the control body. Thermal conductive paste

is recommended. Once the control is operational, it is important to make sure the control is maintaining the desired operating

temperature.

B. Wiring

Wiring is to be done in accordance with all applicable local and state codes. Turn o all power related to the boiler before starting

any wiring procedures.It is recommended that a disconnect switch be installed between the boiler control and the water heater.

Figure 17 - Wiring with Circulators

Figure 18 - Wiring with Zone Valves

C. Wiring Diagrams

CAUTION

When wiring the water heater and controls be sure to label all wires to ease future maintenance. Wiring errors can cause improper

and dangerous operation.

CAUTION

NOTE: DO NOT attempt to remove the control well! The control well is welded to the water heater. Attempting to remove the

control well will result in product damage, leakage, and possible property damage. Such damages are not covered by product

warranty.