Installation Instructions

13
UNIVERSAL ROOF GUY BAND (JURGK) ASSEMBLY INSTRUCTIONS
1. Measure the outside diameter of your chimney.
2. Mark the hole at each end of the band that corresponds to the diameter measured. These 2 holes along with the
"Common" hole will be utilized for your particular chimney.
3. On the "Common" hole assemble 1 carriage bolt, 1 5/16" lock washer, 1 bracket, 1 1/4" lock washer and 1 1/4" hex nut
in place as shown. Do not tighten the nut in place at this time
4. Install the band onto the chimney by placing the second carriage bolt through the correct size square hole, wrap the
band around the chimney, and place the corresponding oval hole over the carriage bolt, and continue to assemble the
remaining hardware as shown above. (On smaller diameter chimney the excess band material should be cut off)
5. Assemble roof guy legs by sliding supplied clamp over larger diameter leg and then inserting smaller diameter leg
into larger diameter leg.
6. Temporarily hold legs together by tightening clamp over cut section of larger diameter leg.
7. Attach the Roof Guy Legs (non-bent end) to the 2 brackets on the band using the 1" slot head screws,
1/4" lockwashers and 1/4" hex nuts.
8. Loosen off roof guy legs, and extend them until they come in contact with the roof surface, and nail in place.
9. Re-tighten clamps on legs, tighten the band and brackets in place, and then tighten the legs to the band.
Carriage Bolt
Band
5/16" Lock Washer
Bracket
1/4" Lock Washer
Nut
12" 11" 10" 9" 8" 7" Common 7" 8" 9" 10" 11" 12"
Cut Section
Clamp
Large Leg
Small Leg
Roof Guy Leg
Roof Guy Band
1/4" Lock Washer
Slot Head Bolt
Nut
Chimney Section
Bracket
Carriage Bolt
Nut
1/4" Lock Washer
5/16" Lock Washer