Installation Guide

When taking up the slack in the rope, be observant of the, WINCH2GO™ unit and watch for binding or
obstructions as the, WINCH2GO™ may move while the slack is removed from the rigging, and during
winching.
During use, avoid long durations of winching.
Stop winching and check the motor for heat.
This is done through the slot opening inside the unit,
providing access to the motor.
NOTE: MOTOR MAY BE HOT. If the winch motor
is hot, allow the winch to cool before
continued winching. See Figure 8.
The winch Users Guide, that accompanies this Technical Installation Manual provides additional
information on rigging techniques and safety precautions.
ALWAYS watch for pinch points and keep all hands away from the winch during
operation.
WINCH2GO™ can be used in a portable fashion by using the supplied straps
and shackles.
Route the rear strap around a tree or secure anchor point, and secure the two loops to the two rear
shackles on the WINCH2GO™ baseplate. ALWAYS be sure that straps do not contact sharp edges or
hot surfaces. See Figure 6.
Freespool the hook and winch rope out to the load and secure using the second supplied strap.
ALWAYS be sure that the hook latch closes around the loop straps. Latch closed with strap loops
inserted in the hook. See Figure 7.
PORTABLE USE
5
Figure 7.
Figure 6.
Figure 8.
Which motor
access slot