Installation Guide

WINCH2 GO™

LOAD

Figure 9.

The Pulley Block is recommended for heavy loads. Run the rope through the Pulley

Block,

and connect

the hook back to the unit using the shackle and front shackle hole on the baseplate. See

Figure 9.

PERMANENT MOUNTED USE

The preferred mounting arrangement is to use the four (4) outer bolt holes in the mounting plate to

mount the unit to a surface. To resist the winching loads a minimum of 1/4” (6mm) mounting plate

thickness should be used. Be certain that the structure used for mounting will resist the winching

loads of the WINCH2GO™. When using the four (4) bolt mounting arrangement, the winch’s wire

rope may be secured back to the front shackle for double-lining. See Figure 10a and 10b.

Figure 10a.

Figure 10b.

WINCH2GO™

4 - Hole Mounting

Pattern dimensions

Do not use “choke” rigging on strap

Do not use strap in single rigging when

winch is doubled lined with pulley block.

Using the supplied M10

mounting bolts, washers,

and nuts, tighten the

mounting hardware

to 32 ft-lb (43 N-m).

WINCH2GO™