Installation Guide

(OPTIONAL) PERMANENT MOUNT

An optional mounting arrangement is to use the two (2) internal bolt holes

with the stiffening plate.

For this option, place the winch Freespool in Disengaged, and spool off enough rope from the winch

drum to insert the steel stiffening plate underneath the winch drum, if it was not Inserted during winch

assembly. To resist the winching loads a minimum of 1/4” (6mm) mounting plate thickness should be

used. Be certain that the structure used for mounting will resist the winching loads of the

WINCH2GO™. Once mounting and wiring is complete, the winch rope may be powered back onto

the drum. See Figure 11a. and 11b.

WHEN USING THE 2 BOLT MOUNTING OPTION, DO NOT USE THE FRONT

SHACKLE HOLE TO DOUBLE-LINE THE PULL BACK TO THE WINCH BASEPLATE. IF

DOUBLE-LINING WITH THE PULLEY BLOCK, ALWAYS SECURE THE WINCH HOOK TO A

NEARBY STRUCTURE, AND NOT THE WINCH BASEPLATE.

WINCH2GO™

2-Hole Mounting

Pattern dimensions

Figure 11a.

Figure 11b.

Using the supplied M10

mounting bolts, washers,

and nuts, tighten the

mounting hardware

to 32 ft-lb (43 N-m).