Owner's manual

The following performance data is shown to provide a guideline of what speed and current are expected at no load and at rated torque

for your Power Drive.

Performance is strongly dependent on voltage applied to the motor. If long lengths of small diameter wire are used, performance will be

severely limited due to the voltage drop caused by the wire. The voltage at the motor should be verified to be at or greater than the

rated voltage specified in Table 2; this will allow the unit to achieve the performance values shown here. It is also important to verify that

adequate current is available to achieve these performance results.

If you require further information on the performance of your Power Drive, contact your Superwinch distributor or Superwinch customer service.

P E R F O R M A N C EP E R F O R M A N C E

DC POWER DRIVE MODELS

No Load Rated Torque

CW @ Output Shaft CCW @ Output Shaft CW @ Output Shaft CCW @ Output Shaft

12V Across Motor - 12V Models

With 10' Total of 8 AWG

24V Across Motor - 24V Models

With 10' Total of 8 AWG

24V Across Motor - 24V Models

Current Current Rated Torque Current Current Current Current

Power Drive #'s RPM (A) RPM (A) (in-lb) RPM (A) RPM (A) RPM (A) RPM (A)

716527 90 25 73 36 750 38 170 51 145 37 190 39 190

716627 87 26 73 29 1040 35 225 48 202 30 260 54 230

716537 90 15 78 17 750 51 70 51 70 45 95 39 105

719527 66 21 57 21 790 34 130 42 117 28 165 36 155

719627 60 17 57 24 1125 28 200 39 205 25 250 42 258

719537 60 14 54 17 790 39 62 42 58 36 79 36 79

719637, 719630 60 15 54 16 1125 32 100 32 105 28 116 27 134

(6 AWG for XXX72X)

Table 2

716727

719727

1200

245

240

245

200

330

300

320