Owner's Manual

The transmitter has one red LED light, see (Fig. 2) which glows when any one
of the buttons is depressed; this shows the receiver is sending a signal to the
receiver.
1. To use the wireless system, the operator rst activates the system by pressing
the red power button on the transmitter; a green LED on the receiver will
glow as the system is now in operational mode and ready for use.
2. To deactivate the wireless system, press the red power button and the green
LED on the receiver turns o as the system is now in standby mode.
3. The power button always has priority and will override all buttons so that it
will put the system into standby mode.
4. If the system is idle for 5 minutes or longer, the system will deactivate and go
into standby mode and will need to be activated prior to use.
Program Red Power Button:
• Press the learn button 1 time
Wait for the red LED on receiver to ash 1 time
• Press the learn button 1 more time
Wait for the red LED on receiver to ash 2 times
• Press the learn button 1 more time
Wait for the red LED on receiver to ash 3 times
• Press the red button on the transmitter and release
• Re-press the red button on the transmitter
The red LED on receiver will now ash to indicate that learning is complete for
the red button
Your transmitter is now programmed and ready for use
Program Green Button 2:
• Press the learn button 1 time
Wait for the red LED on receiver to ash 1 time
• Press the learn button 1 more time
Wait for the red LED on receiver to ash 2 times
• Press green button 2 on the transmitter and release
• Re-press green button 2 on the transmitter
The red LED on receiver will now ash to indicate that learning is complete
for green button 2
5
SPANISH