Owner's Manual

The folowing funtions are built into the system :

1. Standby mode:

When hooked up to the supply voltage, the system is in standby mode

2. Operational mode:

When the system is in operational mode, the green LED on the receiver will

glow and the system is now ready for use.

3. Automatic stop with frequency interference:

The system will automatically move to standby mode when another

transmitter with the same frequency is detected.

Battery

To change the battery, open the back of the transmitter by removing the two

(2) small screws. After removing the cover, carefully remove the old battery and

replace it with a new CR2450 3 volt coin cell battery. Before installing the new

battery insure that the connector is free from corrosion. Corrosion can

be easily removed using a small sti brush. After the new battery has been

installed, replace the cover carefully by means of the two small screws.

After changing the battery make sure the rubber

seal on the transmitter is in place correctly or the sealing of the unit cannot

be guaranteed. Used batteries should be disposed of according to national

regulations.

CAUTION

The transmitter and receiver utilize an internal antenna. This antenna cannot be

shortened, moved or otherwise altered. Alteration will void warranty and may

cause erratic operation.

For safety reasons the receiver also moves to standby mode when more than 5

minutes has elapsed between signals from transmitter to receiver.

The green LED is on when the receiver is on and functional. The red LED ashes

when a button on the transmitter is being pressed.

The receiver works with 3 relays, 2 for direction and 1 for on/o. The relays

switch the current to the proper switch output

SPANISH