User's Manual

5
6
Depending on use, the batteries in the remote transmitters will need
replacement after a period of time. A high capacity battery is recommended
to ensure long life. Use battery part number 23AP or equivalent.
No other regular maintenance is required.
NOTE: Transmitters supplied with unit are pre-programmed
at the factory – DO NOT RE-PROGRAM THEM.
Should a new remote transmitter be purchased it will require programming.
To program, follow the instructions below:
1. Turn the unit power switch ON and OFF ten (10) times or until the red
program LED located in the center of the LED lens of the control
unit illuminates.
2. Press and hold the left button of the remote transmitter until the light
goes off.
3. If programming a second transmitter, wait until the light illuminates again
and immediately press and hold the left button of the second transmitter
until the light goes off.
This must all be done within 10 seconds of the light illuminating.
Test operation to verify proper programming by operating both
remote buttons.
After mounting and wiring is complete, turn the power switch on, test the operation
of the system utilizing the operating switch on the control unit. Then test both
remote transmitters to verify their operation.
OPERATION TESTMAINTENANCE
PROGRAMMING TRANSMITTER
WIRE HOOK-UP
Rope In
Rope Out
Winch In-Out LED
Program LED
Wireless
Control Unit
Antenna
Winch Cable
Winch Socket
Winch
Power On-Off LED
Power Off
Power On
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference and
2. This device must accept any interference received including
interference that may cause undesired operation