User's Manual

9
4.3. Installing the WiFi Network Camera
Using the supplied wall bracket, the WiFi Network Camera can be installed at a xed location.
4.3.1 Attaching the wall bracket
Hold the plate of the wall bracket against the surface of the selected place of installation and,
using a pencil, mark two holes on the surface through the holes in the plate.
To drill the holes for the dowels, use a 6 mm masonry drill bit for stone or concrete walls or
a 3 mm drill bit when attaching to timber. After drilling, insert dowels so that they are ush
with the surface. Then secure the wall bracket using the screws provided in the installation
material.
4.3.2 Securing the WiFi Network Camera
Position the thread of the WiFi Network Camera stand over the retaining plate of the wall
bracket and secure the camera by tightening the stand screw. Using the screw thread, move
the WiFi Network Camera into the desired position
Note:
t 5IF8J'J/FUXPSL$BNFSBTIPVMEOPUCFJOTUBMMFEEJSFDUMZOFYUUPFMFDUSPOJDEFWJDFT
as this could cause interference. If interfere is detected, test camera at another
location rst.
t 8IFOTFMFDUJOHUIFJOTUBMMBUJPOBSFBGPSDBNFSBTFOTVSFUIBUOPTVOMJHIUTIJOFT
into the lens.