User's Manual

BioEntry W
Network Default Setting

In case of forgetting network setting of BioEntry W (TCP/IP or RS-485 setting) during
installation or using BioEntry W, user can initialize network setting (TCP/IP or RS-485
setting) by using DIP SW installed on the back panel of BioEntry W. Please refer to the
figures in below.
How to initialize Network Settin
g
g
z
1. Turn On BioEntry W power.
z
2. Please push the Switch (Please refer to Fig.1
)
2.
Please
push
the
Switch
(Please
refer
to
Fig.1
)
z
3. After turning on BioEntry Plus power, user can modify
TCP/IP or RS-485 setting what user wants.
z
Network Default Setting
z
4
Please modify TCP/IP or RS
-
485 setting and save it
z
Network
Default
Setting
- TCP/IP Address : 192.168.0.1
- Not checked “Use Server”
- RS-485 : PC Connection, 115200bps
4
.
Please
modify
TCP/IP
or
RS
485
setting
and
save
it
.
z
4. Please make DIP SW #2 “OFF” (Please refer to Fig.2)
z
5 After recycling
BioEntry
W power please check the
26
ⒸCopyright 2007 Suprema Inc.
z
5
.
After
recycling
BioEntry
W
power
,
please
check
the
modified TCP/IP or RS-485 setting.