User's Manual

BioAdmin User Manual 100

z On successful verification, the Wiegand string is also sent to the controller,

which can be checked by operation of relay on the controller.

2.4. Quick start with BioEntry Pass

This section describes the basic procedures to operate BioEntry Pass without a

PC device.

2.4.1. Step 1: Hardware installation

In this configuration, the device is connected to an external controller via Wiegand

interface as well as to the host PC through RS485 interface. It is assumed that the

controller supports the standard 26 bit Wiegand format as default of BioEntry

device.

Host PC

Data 1

Access Controller

Data 0

GND

Network

To other controllers

or host computer

TRX+TRX-

WO_D0

WO_D1

WO_GND

TX+

RX+

RX-

TX-

EARTH

BioEntry Pass

POW_GND

POW+

9~24Vdc

Wiegand I/F

RS485

For more details on the installation, refer to the BioEntry Installation manual or

BEACon Operation Manual.

2.4.2. Step 2: Search new device

z Run BioAdmin software.

z Enter Login ID and password. By factory default, the initial Login ID is “admin”

and the password is blank

z Select Device Management on the Main menu, then device management

page will appear on the main window.