User's Manual

BioAdmin User Manual 170

Configuration window shows settings of selected BioEntry Plus device and

enables user to correct those settings. Configuration menu consists of

separated tabs, i.e. operation mode, network, setting, function key, device

setting, image & sound, and notice.

At lower part of configuration window are 4 buttons, i.e. refresh, apply, apply to

others and set to default.

 Refresh : call device setting again.

 Apply : apply corrected setting on the current window to device.

 Apply to others : apply corrected setting on current window to another

device. Device can be selected on select device window.

 Set to default : change setting as default. To apply this value to device,

make sure to press apply button.

4.7.1. Device information

You can check device name, device type, device ID and firmware version of

selected BioStation. Device ID number and firmware version are necessary

information to check a product for technical support after installation.

4.7.2. Operation mode

z Time setting

Date and time shown first are those read from BioEntry Plus. If you click get

time button, it reads date and time from BioEntry once again.

Method of BioEntry time change is divided into direct input and synchronization

with current PC time.

 Direct input : either input numbers directly in date and time window or place

a cursor on a number and click up/down arrow keys for input. Press set

time button after input to transfer input date and time to the selected

BioEntry Plus.

 Synchronization with PC time : check sync with current PC time and set

time button, then selected BioEntry Plus time is set by current PC time.