Installation Guide


*OTUBMMBUJPO
Wiegand connection
6TFBTB8JFHBOEJOQVUPVUQVUEFWJDF



XPass 2
RFID reader /
Control device
12 - WG GND Black
13 - WG D1 White
14 - WG D0 Green
Resetting Network Settings
1
Turn the power on.
2
Press and hold the reset button on the rear of device until the device restart automatically.
3
Connect the device with default values.
•
5$1*1BEESFTT%)$1BEESFTTBTTJHONFOU*G%)$1BEESFTTBTTJHONFOUJTGBJMFEYYXJMMCFTFU
•
4FSWFSNPEF%JTBCMFE
•
34%FGBVMUCQT
4
Change the TCP/IP address or RS-485 information.
5
Turn the power off later on and then check the network setting is properly.
Restoring the Factory Defaults
5IJTXJMMEFMFUFBMMEBUBBOESPPUDFSUJGJDBUFPOUIFEFWJDFBOESFTFUUIFTFUUJOHT
1
Turn the power on.
2
Press the reset button three times quickly.
3
When the green LED is blinking, press the reset button again.
•
If there is no root certificate on the device, you cannot restore the factory defaults.