User Manual

9
PROPRIETARY
PA/LNA bypass and Output DC voltage and enabled for Coax devices and disabled for wireless devices,
respectively.
Auto-connecting (Pairing) a WMR to a Mote
The WMR has the ability to “pair” with a Mote to automatically connect to the device. This option can
be exercised from the WMR menu under “Device Settings”. Refer to the previous section for WMR
setting information. Typically, the Auto Connect option is used after a hardware setup has been
established by the installer.
For example, if your Mote target is serial number 955, you would enter 955 in the auto connect serial
number and check the box for “Enable Auto Connect”
Run Hardware Tests
Suprock telemetry has built in hardware diagnostics. If the user is having an issue or wishes to check the
operating state of the hardware, Run Hardware Tests provides a full report of the functioning of the
telemetry and sensors.
Show Packet Stats
Show Packet stats prompts a report of successful and lost packets, useful for determining the fidelity of
a wireless connection or when optimizing connection in a high obstruction area.