Owner manual

STEP EIGHT

a. Remove two screws from the burner valve

assembly.

b. Carefully insert the valve assembly into the cast

burner. You will need to angle the tube into the

burner assembly. Make certain that the hose is

pointing down when the valve is put in place.

Then push the valve stem out through the open-

ing in the front of the side burner shelf assembly,

lining up the holes on the valve assembly with the

openings on the burner shelf.

c. Place bezel into place, with the "off" position

pointing up, making sure to line up holes.

d. Attach bezel to assembly face with screws removed

in step 8a.

e. Press knob onto valve assembly stem.

SS 4 Assembly

close-up of step 8b